Zoom F8n - Setting the Attack Time; Setting the Release Time

Output settings
Output Limiter
120
Output Limiter (continued)
Setting the release time
This sets the amount of time until limiting stops after the out-
put signal goes below the threshold.
5. Use to select Release
Time
, and press .
6. Use to adjust the time,
and press
.
HINT
This can be set from 1 to 500 ms.
Setting the attack time
This sets the amount of time until limiting starts after the out-
put signal exceeds the threshold.
5. Use to select Attack
Time
, and press .
6. Use to adjust the time,
and press
.
HINT
This can be set from 1 to 4 ms.