Timecode
Setting timecode functions
128
Setting timecode functions (continued)
Setting value Explanation
Ext Auto Rec
The internal timecode will chase the external timecode.
You can also enable the automatic generation of internal
timecode when there is no external timecode. (→ P.129)
Recording starts automatically when external timecode
input is detected. Recording stops automatically when
external timecode stops.
Stopping timecode output when recording is stopped
You can set whether or not timecode is output from the
TIMECODE OUT jack when recording is stopped.
4. Use to select
Mode
,
and press
.
5. Use to select
Int Auto
Mute
, and press .
6. Use to select
On
,
and press
.
NOTE
• Timecode will continue to be output when recording/playback is
paused.
• This cannot be set when Mode is set to Off, Int Record Run, Ext
or Ext Auto Rec.
Setting timecode functions (continued)
To Next Page
Loading...
