Recording take settings
Setting the take name reset condition and format
46
Setting the take name reset condition and format
1. Press .
2. Use to select
META
DATA (for Next Take)
,
and press
.
▶ Continue to one of the following procedures.
Setting the take name reset condition................P.46
Setting the take name format.......................P.47
Setting the take name reset condition
3. Use to select
Take Reset
Mode
, and press .
4. Use to select the reset
mode, and press
.
Setting value Explanation
Off
The take number will not be reset.
However, if the folder is changed and that folder con-
tains a number higher than the current take number,
the take number will be set to one higher than the
highest existing take number.
Folder Change
If the destination folder is changed, the take number
will be set to one higher than the highest take number
in that folder.
You can set the take name reset condition and format used when recording.
To Next Page
Loading...
