Zoom F8n - Correcting Timecode Errors

Correcting timecode errors after the power has been
turned off
When the mode of Start Timecode is set to RTC, turning the
power off lowers the timecode precision, but this function
can be used to improve precision to within 0.2 ppm when the
power has been turned off.
4. Use to select RTC
Timecode Calibration
, and
press
.
5. Use to select
Recalibrate , and press .
6. Use to select Yes , and
press
.
7. Calibration completes.
8. To cancel calibration, press
, and use to select
Yes, and press
.
NOTE
• The is calibrated before being shipped new from the factory.
• After calibrating once, the result will be retained.
• If the is moved to and used in an extremely hot or cold loca-
tion, timecode precision could change slightly when the power is
turned off. In such cases, we recommend calibrating it again.
• Calibration is not possible when Audio Out From USB is set to On.
• Calibration is only possible when Start Timecode mode is set to RTC.
• Calibration is not possible when an is connected.
Timecode
Setting timecode initialization used at startup (Start Timecode)
135
F8n Multi Track Field Recorder