Zoom F8n - Page 86

Setting the attack time
This sets the amount of time until limiting starts after the
input signal exceeds the threshold.
5. Use to select Attack
Time
, and press .
6. Use to adjust the time,
and press
.
HINT
This can be set from 1 to 4 ms.
NOTE
This setting can be made when On/Off is set to On (Normal).
Setting the threshold
This sets the level at which the limiter begins operating.
5. Use to select Threshold ,
and press
.
6. Use to adjust the
setting, and press
.
HINT
This can be set from −16 to −2 dBFS.
NOTE
This setting can be made when On/Off is set to On (Normal).
Input settings
Input limiter
86
Input limiter (continued)