Zte ZXR10 5900E Series - Configuring Sflow; Sflow Configuration Example

Chapter15SowConguration
ConfiguringsFlow
1.Toenable/disablesowmodule,usethefollowingcommand.
CommandFunction
ZXR10(config)#sflow{enable|disable}Thisenables/disablessow
module.
2.ToconguresowAgent,usethefollowingcommand.
St-
ep
CommandFunction
1
ZXR10(config)#sflowagent-configipv4-address
A.B.C.D[udp_port]
ThisconguressFlowAgent
IPaddress.
2
ZXR10(config)#sflowagent-configipv6-address
X:X::X:X[udp_port]
ThisconguressFlowAgent
IPv6address.
3.ToconguresFlowCollector ,usethefollowingcommand.
St-
ep
CommandFunction
1
ZXR10(config)#sflowcollector-configipv4-address
A.B.C.D[udp_port]
ThisconguressFlow
CollectorIPaddress.
2
ZXR10(config)#sflowcollector-configipv6-address
X:X::X:X[udp_port]
ThisconguressFlow
CollectorIPv6address.
4.ToconguresFlowsamplingrate,usethefollowingcommand.
CommandFunction
ZXR10(config-gei_1/x)#sflow-sample-rate{ingress|
egress}<ratevalue>
ThisconguressFlowsampling
rateontheinterface.
SFlowConfiguration
Example
ThenetworkinggureisasshowninFigure32.
CondentialandProprietaryInformationofZTECORPORATION125