29
4.7
Software Update
Prepare the USB for update
Unzip the file named "update.tar.gz", and then copy the "update" directory in the unzipped file to
the root directory of the formatted USB.
The USB should have been formatted to FAT32 before you copy and paste the "update"
directory to it.
Update
Insert the USB to one of the USB ports on the analyzer, and perform update.
Do not pull the USB or disconnect power during the update; otherwise the analyzer may
not start.
The update usually takes some minutes, but depends on the number of modules to be
updated. Do not leave the analyzer as the process requires user operation.
When update fails
If the update fails, try again.
To Next Page
Loading...