Chapter 8 Home Networking
AMG1302-T11C User’s Guide
124
The following table describes the labels in this screen.
8.5 The UPnP Screen
Universal Plug and Play (UPnP) is a distributed, open networking standard that uses TCP/IP for
simple peer-to-peer network connectivity between devices. A UPnP device can dynamically join a
network, obtain an IP address, convey its capabilities and learn about other devices on the network.
In turn, a device can leave a network smoothly and automatically when it is no longer in use.
See page 119 for more information on UPnP.
Use the following screen to enable or disable the UPnP function on your AMG1302-T11C. Click
Network Setting > Home Networking > UPnP to display the screen shown next.
Figure 53 Network Setting > Home Networking > UPnP
The following table describes the labels in this screen.
8.6 The IPv6 LAN Setup Screen
Use this screen to configure the IPv6 settings for your AMG1302-T11C’s LAN interface. See
Appendix F on page 279 for background information about IPv6.
Table 35 Network Setting > Home Networking > IP Alias
LABEL DESCRIPTION
IP Alias Select Enable to configure a LAN network for the AMG1302-T11C.
IP Address Enter the IP address of your AMG1302-T11C in dotted decimal notation.
IP Subnet Mask Type the subnet mask of your network in dotted decimal notation, for example
255.255.255.0 (factory default).
Apply Click this to save your changes.
Cancel Click this to restore your previously saved settings.
Table 36 Network Setting > Home Networking > UPnP
LABEL DESCRIPTION
UPnP Select Enable to activate UPnP. Be aware that anyone could use a UPnP application to open the
web configurator's login screen without entering the AMG1302-T11C's IP address (although you
must still enter the password to access the web configurator). Otherwise, select Disable to
deactivate UPnP.
Apply Click Apply to save your changes.
Cancel
Click Cancel to exit this screen without saving.
To Next Page
Loading...
