ZyXEL Communications AMG1302-T11C - Using the Reset Button; Ways to Manage the AMG1302-T11 C

Chapter 1 Introduction
AMG1302-T11C User’s Guide
17
1.7.1 Using the Reset Button
1 Make sure the POWER LED is on (not blinking).
2 To set the device back to the factory default settings, press the RESET button for ten seconds or
until the POWER LED begins to blink and then release it. When the POWER LED begins to blink,
the defaults have been restored and the device restarts.
1.8 Ways to Manage the AMG1302-T11C
Use any of the following methods to manage the AMG1302-T11C.
• Web Configurator. This is recommended for everyday management of the AMG1302-T11C using a
(supported) web browser.
• FTP for firmware upgrades and configuration backup/restore.