Chapter 7 Wireless LAN
AMG1302-T11C User’s Guide
98
Figure 34 Network Setting > Wireless > MAC Authentication: Add/Edit
The following table describes the fields in this screen.
7.5 The WPS Screen
Use this screen to configure WiFi Protected Setup (WPS) on your AMG1302-T11C.
WPS allows you to quickly set up a wireless network with strong security, without having to
configure security settings manually. Set up each WPS connection between two devices. Both
devices must support WPS. See Section 7.10.8.3 on page 113 for more information about WPS.
Note: The AMG1302-T11C applies the security settings configured in the General screen
(see Section 7.2 on page 88). If you want to use the WPS feature, make sure you
have set the security mode to WPA-PSK, WPA2-PSK or No Security.
Click Network Setting > Wireless > WPS. The following screen displays. Select Enable and click
Apply to activate the WPS function. Then you can configure the WPS settings in this screen.
Table 23 Network Setting > Wireless > MAC Authentication: Add/Edit
LABEL DESCRIPTION
Mac Address Enter the MAC addresses of the wireless devices that are allowed or denied access to
the AMG1302-T11C in these address fields. Enter the MAC addresses in a valid MAC
address format, that is, six hexadecimal character pairs, for example,
12:34:56:78:9a:bc.
OK Click OK to save your changes.
Cancel Click Cancel to exit this screen without saving.
To Next Page
Loading...
