Chapter 1 Introduction
AMG1302-T11C User’s Guide
15
1.5 LED (Lights)
The following graphic displays the labels of the LEDs.
Figure 3 LEDs on the AMG1302-T11C
The following table describes the LEDs..
Table 1 LED Descriptions
LED COLOR STATUS DESCRIPTION
POWER
Green On The AMG1302-T11C is receiving power and ready for use.
Blinking The AMG1302-T11C is self-testing.
Red On The AMG1302-T11C detected an error while self-testing, or there
is a device malfunction.
Off The AMG1302-T11C is not receiving power.
Ethernet 1-4
Green On The AMG1302-T11C has an Ethernet connection with a device on
the Local Area Network (LAN).
Blinking The AMG1302-T11C is sending/receiving data to /from the LAN.
Off The AMG1302-T11C does not have an Ethernet connection with
the LAN.
WLAN
Green On The wireless network is activated.
Blinking The AMG1302-T11C is communicating with other wireless clients.
Off The wireless network is not activated.
WPS
Green Blinking The AMG1302-T11C is setting up a WPS connection.
On The WPS connection is successfully made. The LED turns off after
two minuters.
Off WPS is disabled.
DSL
Green On The DSL line is up.
Blinking The AMG1302-T11C is initializing the DSL line.
Off The DSL line is down.
INTERNET
Green On The AMG1302-T11C has an IP connection but no traffic.
Your device has a WAN IP address (either static or assigned by a
DHCP server), PPP negotiation was successfully completed (if
used) and the DSL connection is up.
Blinking The AMG1302-T11C is sending or receiving IP traffic.
Red On The AMG1302-T11C attempted to make an IP connection but
failed. Possible causes are no response from a DHCP server, no
PPPoE response, PPPoE authentication failed.
Off The AMG1302-T11C does not have an IP connection.
To Next Page
Loading...
