Chapter 27 Remote Management
AMG1302-T11C User’s Guide
212
The following table describes the fields in this screen.
27.3 The SNMP Screen
Simple Network Management Protocol is a protocol used for exchanging management information
between network devices. Your AMG1302-T11C supports SNMP agent functionality, which allows a
manager station to manage and monitor the AMG1302-T11C through the network. The AMG1302-
T11C supports SNMP version one (SNMPv1), version two (SNMPv2c), and version three (SNMPv3).
The next figure illustrates an SNMP management operation.
Figure 121 SNMP Management Model
Table 87 Maintenance > Remote MGMT
LABEL DESCRIPTION
WAN Interface
used by
services
Select Any_WAN to have the AMG1302-T11C automatically activate the remote
management service when any WAN connection is up.
Select Multi_WAN and then select one or more WAN connections to have the AMG1302-
T11C activate the remote management service when the selected WAN connections are up.
Services This is the service you may use to access the AMG1302-T11C.
LAN/WLAN Select the Enable check box for the corresponding services that you want to allow access to
the AMG1302-T11C from the LAN/WLAN.
WAN Select the Enable check box for the corresponding services that you want to allow access to
the AMG1302-T11C from all WAN connections.
WAN Trust
Domain
If you only want certain WAN connections to have access to to the AMG1302-T11C using the
corresponding services, then clear the Enable check box in the WAN column, select the
Enable check box in the WAN Trust Domain column and configure the allowed IP
address(es) in the Trust Domain screen.
Port You may change the server port number for a service if needed, however you must use the
same port number in order to use that service for remote management.
Apply Click Apply to save your changes back to the AMG1302-T11C.
Cancel Click Cancel to restore your previously saved settings.
To Next Page
Loading...
