ZyXEL Communications AMG1302-T11C - MAC Address Add;Edit

Chapter 7 Wireless LAN
AMG1302-T11C User’s Guide
97
Use this screen to view your AMG1302-T11C’s MAC filter settings and add new MAC filter rules.
Click Network Setting > Wireless > MAC Authentication. The screen appears as shown.
Figure 33 Network Setting > Wireless > MAC Authentication
The following table describes the labels in this screen.
7.4.1 MAC Address Add/Edit
Use this screen to add or edit a MAC address. Click the Add new MAC address button or the Edit
icon next to a MAC address entry in the MAC Authentication screen. The following screen
displays.
Table 22 Network Setting > Wireless > MAC Authentication
LABEL DESCRIPTION
SSID Select the SSID for which you want to configure MAC filter settings.
MAC Restrict
Mode
Define the filter action for the list of MAC addresses in the MAC address table.
Select Disable to turn off MAC filtering.
Select Allow to permit access to the AMG1302-T11C. MAC addresses not listed will be
denied access to the AMG1302-T11C.
Select Deny to block access to the AMG1302-T11C. MAC addresses not listed will be allowed
to access the AMG1302-T11C.
Add new MAC
address
Click this if you want to add a new MAC address entry to the MAC filter list below.
# This is the index number of the entry.
MAC Address This is the MAC addresses of the wireless devices that are allowed or denied access to the
AMG1302-T11C.
Modify Click the Edit icon to change the MAC address.
Click the Delete icon to delete the entry.
Apply Click Apply to save your changes.
Cancel Click Cancel to exit this screen without saving.