Chapter 7 Wireless LAN
AMG1302-T11C User’s Guide
90
7.2.1 No Security
Select No Security to allow wireless stations to communicate with the access points without any
data encryption or authentication.
Note: If you do not enable any wireless security on your AMG1302-T11C, your network is
accessible to any wireless networking device that is within range.
Figure 27 Wireless > General: No Security
7.2.2 Basic (WEP Encryption)
WEP encryption scrambles the data transmitted between the wireless stations and the access points
(AP) to keep network communications private. Both the wireless stations and the access points
must use the same WEP key.
Channel
Selection
Set the operating channel manually by selecting a channel from the Channel Selection
list or use Auto to have it automatically determine a channel to use.
Operating
Channel
This field displays the channel the AMG1302-T11C is currently using.
Enhanced
Multicast
Forwarding
Select Enable to allow the AMG1302-T11C to convert wireless multicast traffic into
wireless unicast traffic.
Max. Upstream
Bandwidth
Specify the maximum rate for upstream wireless traffic to the WAN from this WLAN in
kilobits per second (Kbps).
Max.
Downstream
Bandwidth
Specify the maximum rate for downstream wireless traffic to this WLAN from the WAN in
kilobits per second (Kbps).
Security Level
Security Mode Select Basic (WEP) or More Secure (WPA(2)-PSK, WPA(2)) to add security on this
wireless network. The wireless clients which want to associate to this network must have
same wireless security settings as the AMG1302-T11C. When you select to use a security,
additional options appears in this screen.
Or you can select No Security to allow any client to associate this network without any
data encryption or authentication.
See the following sections for more details about this field.
Apply Click this to save your changes.
Cancel Click this to restore your previously saved settings.
Table 16 Network Setting > Wireless > General
LABEL DESCRIPTION
To Next Page
Loading...
