Chapter 27 Remote Management
AMG1302-T11C User’s Guide
211
•Use the Trust Domain screen (Section 27.4 on page 214) to view and configure a list of public
IP addresses which are allowed to access the AMG1302-T11C through the services configured in
the Remote MGMT screen.
27.1.2 What You Need to Know About Remote Management
Remote Management Limitations
Remote management does not work when:
• You have not enabled that service on the interface in the corresponding remote management
screen.
• You have disabled that service in one of the remote management screens.
• The IP address in the Trust Domain screen does not match the client IP address. If it does not
match, the AMG1302-T11C will disconnect the session immediately.
• There is a firewall rule that blocks it.
Remote Management and NAT
When NAT is enabled:
• Use the AMG1302-T11C’s WAN IP address when configuring from the WAN.
• Use the AMG1302-T11C’s LAN IP address when configuring from the LAN.
27.2 The Remote MGMT Screen
Use this screen to configure through which interface(s), which services can access the AMG1302-
T11C. You can also specify the port numbers the services must use to connect to the AMG1302-
T11C. Click Maintenance > Remote MGMT to open the following screen.
Figure 120 Maintenance > Remote MGMT
To Next Page
Loading...
