ZyXEL Communications AMG1302-T11C - Main Window; Navigation Panel

Chapter 2 Introducing the Web Configurator
AMG1302-T11C User’s Guide
22
2.2.2 Main Window
The main window displays information and configuration fields. It is discussed in the rest of this
document.
After you click System Info on the Connection Status screen, the System Info screen is
displayed. See Chapter 5 on page 62 for more information about the System Info screen.
If you click LAN Device on the System Info screen, the Connection Status screen appears. See
Chapter 5 on page 61 for more information about the Connection Status screen.
2.2.3 Navigation Panel
Use the menu items on the navigation panel to open screens to configure AMG1302-T11C features.
The following table describes each menu item.
Table 2 Navigation Panel Summary
LINK TAB FUNCTION
Connection Status This screen shows the network status of the AMG1302-T11C and
computers/devices connected to it.
Network Setting
Broadband Internet
Connections
Use this screen to configure ISP parameters, WAN IP address
assignment, DNS servers and other advanced properties.
More Connections Use this screen to configure additional WAN connections.
This screen is not available when the Line Type is set to
Ethernet(ETH1) in the Internet Connection screen.
Wireless General Use this screen to turn the wireless connection on or off, specify
the SSID(s) and configure the wireless LAN settings and WLAN
authentication/security settings.
More/guest AP Use this screen to configure multiple BSSs on the AMG1302-T11C.
MAC
Authentication
Use this screen to block or allow wireless traffic from wireless
devices of certain SSIDs and MAC addresses to the AMG1302-
T11C.
WPS Use this screen to use WPS (Wi-Fi Protected Setup) to establish a
wireless connection.
WDS
Use this screen to set up Wireless Distribution System (WDS) links
to other access points.
WMM Use this screen to enable or disable Wi-Fi MultiMedia (WMM).
Scheduling Use this screen to configure when the AMG1302-T11C enables or
disables the wireless LAN.
Advanced Use this screen to configure advanced wireless settings such as
output power.