ZyXEL Communications AMG1302-T11C - Page 196

Chapter 21 TR-069 Client
AMG1302-T11C User’s Guide
196
Figure 106 Maintenance > TR-069 Client
The following table describes the fields in this screen.
Table 81 Maintenance > TR-069 Client
LINK DESCRIPTION
CWMP Select Enable to allow the AMG1302-T11C to be managed by a management server or
select Disable to not allow the AMG1302-T11C to be managed by a management server.
ACS URL Type the IP address or domain name of the management server. If the AMG1302-T11C is
behind a NAT router that assigns it a private IP address, you will have to configure a NAT
port forwarding rule on the NAT router.
Generate
password
automatically
Select this option to have the AMG1302-T11C automatically generate a password. The user
name and password fields will not be configurable when you select this option.
ACS User Name The user name is used to authenticate the AMG1302-T11C when making a connection to the
management server. This user name on the management server and the AMG1302-T11C
must be the same. Type a user name of up to 255 printable characters found on an English-
language keyboard. Spaces and characters such as @#$%^&*()_+ are allowed.
ACS Password The password is used to authenticate the AMG1302-T11C when making a connection to the
management server. This password on the management server and the AMG1302-T11C
must be the same. Type a password of up to 255 printable characters found on an English-
language keyboard.
Display SOAP
messages on
serial console
Select Enable to show the SOAP messages on the console.
Connection
Request Path
Type the IP address or domain name of the AMG1302-T11C. The management server uses
this path to verify the AMG1302-T11C.
Connection
Request Port
The default port for access to the AMG1302-T11C from the management server is port
7547. If you change it, make sure it does not conflict with another port on your network and
it is recommended to use a port number above 1024 (not a commonly used port). The
management server should use this port to connect to the AMG1302-T11C. You may need to
alter your NAT port forwarding rules if they were already configured.
Connection
Request User
Name
The user name is used to authenticate the management server when connecting to the
AMG1302-T11C. Type a user name of up to 255 printable characters found on an English-
language keyboard. Spaces and characters such as @#$%^&*()_+ are allowed.
Connection
Request
Password
The password is used to authenticate the management server when connecting to the
AMG1302-T11C. Type a password of up to 255 printable characters found on an English-
language keyboard. Spaces are not allowed.