Chapter 24 Log Setting
AMG1302-T11C User’s Guide
203
Mode Select the syslog destination from the drop-down list box.
If you select Local File, the log(s) will be saved in a local file. If you want to send the log(s)
to a remote syslog server and save it in a local file, select Local File and Remote.
Syslog Server
IP Address
Enter the server name or IP address of the syslog server that will log the selected categories
of logs.
Syslog Server
UDP Port
Enter the port number used by the syslog server.
E-mail Log Settings
SMTP
Authentication
Select this check box if it is necessary to provide a user name and password to the SMTP
server.
Mail Server Enter the server name or the IP address of the mail server for the e-mail addresses
specified below. If this field is left blank, logs and alert messages will not be sent via E-mail.
Mail Subject Type a title that you want to be in the subject line of the system log e-mail message that
the AMG1302-T11C sends.
From Type the e-mail address from which the outgoing e-mail is delivered. This address is used in
replies.
To Type the e-mail address (or addresses) to which the outgoing e-mail is delivered. If this
field is left blank, the AMG1302-T11C does not send logs via E-mail.
User Name This box is effective when you select the SMTP Authentication check box. Type the user
name to provide to the SMTP server when the log is e-mailed.
Password This box is effective when you select the SMTP Authentication check box. Type the
password to provide to the SMTP server when the log is e-mailed.
Log Schedule Set the frequency of log messages being sent as E-mail:
•Daily
• Weekly
•Hourly
• When Log is Full
•None.
If you select Weekly or Daily, specify a time of day when the E-mail should be sent. If you
select Weekly, then also specify which day of the week the E-mail should be sent. If you
select When Log is Full, an alert is sent when the log fills up. If you select None, no log
messages are sent.
Day For
Sending Log
Select which day of the week to send the logs.
Time for
Sending Log
Enter the time of the day in 24-hour format (for example 23:00 equals 11:00 pm) to send
the logs.
Clear log after
sending mail
Select this to delete all the logs after the AMG1302-T11C sends an E-mail of the logs.
Email Alarm Log Settings
Send Alarm to Alerts are real-time notifications that are sent as soon as an event, such as a DoS attack,
system error, or forbidden web access attempt occurs. Enter the E-mail address where the
alert messages will be sent. Alerts include system errors, attacks and attempted access to
blocked web sites. If this field is left blank, alert messages will not be sent via E-mail.
Alarm Interval Specify how often the alarm should be updated.
Active Log and Select Level
Log Category Select the categories of logs that you want to record.
Log Level Select the severity level of logs that you want to record. If you want to record all logs, select
ALL.
Table 84 Maintenance > Logs Setting (continued)
LABEL DESCRIPTION
To Next Page
Loading...
