Chapter 27 Remote Management
AMG1302-T11C User’s Guide
216
Figure 125 Maintenance > Remote MGMT > Trust Domain > Add Trust Domain (IPv6)
The following table describes the fields in this screen.
Table 90 Maintenance > Remote MGMT > Trust Domain > Add Trust Domain
LABEL DESCRIPTION
IP Version Type Select the IP version, IPv4 or IPv6, to apply this rule to.
Address Type Do you want to allow a particular (single) IP, a range of IP addresses (for instance,
192.168.1.10 to 192.169.1.50), or a subnet to access the AMG1302-T11C? Select an option
from the drop-down list box that includes: Single Address, Range Address, and Subnet
Address.
Start IP
Address
Specify the public IP address(es) which is allowed to access the service on the AMG1302-
T11C from the WAN.
Enter the single IP address or the starting IP address in a range here.
End IP Address Enter the ending IP address in a range here.
Subnet Mask Enter the subnet mask here if you sent IP Version Type to IPv4.
Prefix Length Enter the prefix length for the IPv6 address.
An IPv6 prefix length specifies how many most significant bits (starting from the left) in the
address compose the network address. This indicates the bit number of the IPv6 subnet
mask.
Apply Click Apply to save your changes back to the AMG1302-T11C.
Cancel Click Cancel to return to the previous screen without saving.
To Next Page
Loading...
