ZyXEL Communications AMG1302-T11C - Page 29

Chapter 3 Quick Start Wizard
AMG1302-T11C User’s Guide
29
Figure 12 Internet Connection with PPPoE
The following table describes the fields in this screen.
• If the user name and/or password you entered for PPPoE or PPPoA connection are not correct,
you are prompted to enter the correct information.
• If the Internet connection fails, check to see if your account is activated.
Table 6 Internet Connection with PPPoE
LABEL DESCRIPTION
User Name Enter the user name exactly as your ISP assigned. If assigned a name in the form
user@domain where domain identifies a service name, then enter both components exactly
as given.
Password Enter the password associated with the user name above.
Multiplex Select the multiplexing method used by your ISP from the Multiplex drop-down list box
either VC-based or LLC-based.
VPI Enter the Virtual Path Identifier (VPI) assigned to you. This field may already be configured.
VCI Enter the Virtual Channel Identifier (VCI) assigned to you. This field may already be
configured.
Select Yes to enter specific IP information from your Internet service provider. Enter your Internet access
information exactly as your service provider gave it to you.
IP Address Enter the IP address of the AMG1302-T11C.
Primary DNS
Server
Enter the primary DNS server IP address for the AMG1302-T11C.
Secondary DNS
Server
Enter the secondary DNS server IP address for the AMG1302-T11C.
Back Click this to return to the previous screen without saving.
Next Click this to continue to the next wizard screen. The next wizard screen you see depends on
what protocol you chose above.
Close Click this to close the wizard screen without saving.