ZyXEL Communications GS1350 Series - 8.8.2 PoE Setup

Chapter 8 Basic Setting
GS1350 Series User’s Guide
104
Figure 80 Basic Setting > PoE Setup > PoE Time Range Setup
The following table describes the labels in this screen.
8.8.2 PoE Setup
Use this screen to set the PoE power management mode, priority levels, power-up mode and the
maximum amount of power for the connected PDs.
Click the PoE Setup link in the Basic Setting > PoE Status screen. The following screen opens.
Table 34 Basic Setting > PoE Setup > PoE Time Range Setup
LABEL DESCRIPTION
Port Enter the number of the port to which you want to apply a schedule.
Time Range This field displays the name of the schedule that you have created using the Advanced
Application > Time Range screen.
Select a pre-defined schedule to control when the Switch enables PoE to provide power on the
port. To select more than one schedule, press [SHIFT] and select the choices at the same time.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Clear Click Clear to clear the fields to the factory defaults.
Port This field displays the index number of the port. Click a port number to change the schedule
settings.
Time Range
Profiles
This field displays the name of the schedule which is applied to the port.
PoE is enabled at the specified time or date.
Select an entry’s check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Delete Check the rules that you want to remove and then click the Delete button.
Cancel Click Cancel to clear the selected check boxes.