Chapter 46 Quick Setup
GS1350 Series User’s Guide
327
CHAPTER 46
Quick Setup
Use the Quick Setup screen to display the IP Address Information of the Switch and links to the IP Setup,
Auto PD Recovery, PoE Setup, Port Setup, and ONVIF screens.
46.1 Quick Setup Screen
Click Quick Setup in the navigation panel to display this screen.
Figure 241 Quick Setup
The following table describes the labels in this screen.
Table 164 Quick Setup
LABEL DESCRIPTION
IP Address Information
IPv4 Address This displays the IP address of the Switch for it to be managed over the network.
Subnet Mask This displays the subnet mask that specifies the network number portion of an IP address.
Default Gateway This displays the IP address of the default outgoing gateway in dotted decimal notation.
IP Setup This link takes you to a screen where you can configure the IP address and subnet mask
(necessary for Switch management) and set up to 64 IP routing domains.
Quick Links
Auto Camera
Recovery
This link takes you to a screen where you can enable and configure Auto PD Recovery on the
Switch.
PoE Setup This link takes you to a screen where you can set priorities, PoE power-up settings and schedule
so that the Switch is able to reserve and allocate power to certain PDs.
Extended Range
& Port Setup
This link takes you to a screen where you can configure settings for individual Switch ports.
ONVIF This link takes you to a screen where you can configure a specific VLAN to run ONVIF.
To Next Page
Loading...
