ZyXEL Communications GS1350 Series - 27.6.1 LLDP Configuration Basic TLV Setting

Chapter 27 Link Layer Discovery Protocol (LLDP)
GS1350 Series User’s Guide
223
27.6.1 LLDP Configuration Basic TLV Setting
Use this screen to configure Basic TLV settings. Click Advanced Application > LLDP > LLDP Configuration
(Click Here) > Basic TLV Setting to display the screen as shown next.
Figure 162 Advanced Application > LLDP > LLDP Configuration> Basic TLV Setting
The following table describes the labels in this screen.
Admin Status Select whether LLDP transmission and/or reception is allowed on this port.
• Disable – not allowed
• Tx-Only – transmit only
• Rx-Only – receive only
• Tx-Rx – transmit and receive
Notification Select whether LLDP notification is enabled on this port.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 101 Advanced Application > LLDP > LLDP Configuration (continued)
LABEL DESCRIPTION
Table 102 Advanced Application > LLDP > LLDP Configuration > Basic TLV Setting
LABEL DESCRIPTION
Port This displays the Switch’s port number.
* Use this row to make the setting the same for all ports. Use this row first and then make
adjustments to each port if necessary.
Changes in this row are copied to all the ports as soon as you make them.
Management
Address
Select the check boxes to enable or disable the sending of Management Address TLVs on
the ports.
Port Description Select the check boxes to enable or disable the sending of Port Description TLVs on the ports.
System Capabilities Select the check boxes to enable or to disable the sending of System Capabilities TLVs on the
ports.
System Description Select the check boxes to enable or to disable the sending of System Description TLVs on the
ports.
System Name Select the check boxes to enable or to disable the sending of System Name TLVs on the
ports.