ZyXEL Communications GS1350 Series - 38.2 Cluster Management Status

Chapter 38 Cluster Management
GS1350 Series User’s Guide
300
• Use the Clustering Management Configuration screen (Section 38.1 on page 299) to configure
clustering management.
38.2 Cluster Management Status
Use this screen to view the role of the Switch within the cluster and to access a cluster member Switch’s
Web Configurator.
Click Management > Cluster Management in the navigation panel to display the following screen.
Note: A cluster can only have one manager.
Figure 223 Management > Cluster Management Status
The following table describes the labels in this screen.
Table 149 Management > Cluster Management Status
LABEL DESCRIPTION
Status This field displays the role of this Switch within the cluster.
Manager
Member (you see this if you access this screen in the cluster member Switch directly and not via
the cluster manager)
None (neither a manager nor a member of a cluster)
Manager This field displays the cluster manager Switch’s hardware MAC address.
The Number of
Member
This field displays the number of switches that make up this cluster. The following fields describe
the cluster member switches.
Index You can manage cluster member switches via the cluster manager Switch. Each number in the
Index column is a hyperlink leading to the cluster member Switch’s Web Configurator (see Figure
225 on page 303).
MacAddr This is the cluster member Switch’s hardware MAC address.
Name This is the cluster member Switch’s System Name.
Model This field displays the model name.
Status This field displays:
Online (the cluster member Switch is accessible)
Error (for example the cluster member Switch password was changed or the Switch was set as
the manager and so left the member list, and so on)
Offline (the Switch is disconnected – Offline shows approximately 1.5 minutes after the link
between cluster member and manager goes down)