ZyXEL Communications GS1350 Series - 33.4 Restore Configuration

Chapter 33 Maintenance
GS1350 Series User’s Guide
261
Type the path and file name of the firmware file you wish to upload to the Switch in the File Path text box
or click Choose File to locate it. Upgrades are only applied after a reboot. Click Upgrade to load the
new firmware.
After the process is complete, see the System Info screen to verify your current firmware version number.
33.4 Restore Configuration
Use this screen to restore a previously saved configuration from your computer to the Switch.
Figure 194 Management > Maintenance > Restore Configuration
Type the path and file name of the configuration file you wish to restore in the File Path text box or click
Choose File/Browse to locate it. After you have specified the file, click Restore. "config" is the name of
the configuration file on the Switch, so your backup configuration file is automatically renamed when
you restore using this screen.
Table 125 Management > Maintenance > Firmware Upgrade
LABEL DESCRIPTION
Name This is the name of the Switch that you are configuring.
Version The Switch has 2 firmware sets, Firmware 1 and Firmware 2, residing in flash.
• Running shows the version number (and model code) and MM/DD/YYYY creation date
of the firmware currently in use on the Switch (Firmware 1 or Firmware 2). The firmware
information is also displayed at System Information in Basic Settings.
• Firmware 1 shows its version number (and model code) and MM/DD/YYYY creation
date.
• Firmware 2 shows its version number (and model code) and MM/DD/YYYY creation
date.
Current Boot Image This displays which firmware is currently in use on the Switch (Firmware 1 or Firmware 2).
Config Boot Image Select which firmware (Firmware 1 or Firmware 2) should load, click Apply and reboot the
Switch to see changes, you will also see changes in the Current Boot Image field above as
well.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Firmware Choose to upload the new firmware to (Firmware) 1 or (Firmware) 2.
File Path Type the path and file name of the firmware file you wish to upload to the Switch in the File
Path text box or click Choose File or Browse to locate it.
Upgrade Click Upgrade to load the new firmware. s are only applied after a reboot. To reboot, go to
Management > Maintenance > Reboot System and click Config 1, Config 2 or Factory
Default (Config 1, Config 2 and Factory Default are the configuration files you want the
Switch to use when it restarts).