Chapter 8 Basic Setting
GS1350 Series User’s Guide
88
CHAPTER 8
Basic Setting
8.1 Overview
This chapter describes how to configure the System Info, General Setup, Switch Setup, IP Setup, Port
Setup, PoE Setup, Interface Setup, IPv6, and Cloud Management screens.
8.1.1 What You Can Do
• Use the System Info screen (Section 8.2 on page 88) to check the firmware version number and
monitor the Switch temperature.
• Use the General Setup screen (Section 8.3 on page 90) to configure general settings such as the
system name and time.
• Use the Switch Setup screen (Section 8.5 on page 92) to choose your VLAN type and assign priorities
to queues.
• Use the IP Setup screen (Section 8.6 on page 94) to configure the Switch IP address, default gateway
device, management VLAN ID, and proxy server.
• Use the Port Setup screen (Section 8.7 on page 99) to configure Switch port settings.
• Use the PoE Setup screens (Section 8.8 on page 101) to view the current amount of power that PDs
are receiving from the Switch and set the priority levels for the Switch in distributing power to PDs. This
screen is available for PoE model(s) only.
• Use the Interface Setup screens (Section 8.9 on page 107) to configure Switch interface type and
interface ID settings.
• Use the IPv6 screens (Section 8.10 on page 108) to view IPv6 status and IPv6 configuration.
• Use the Cloud Management screen (Section 8.11 on page 119) to display links to Nebula Control
Center Discovery and Nebula Switch Registration screens.
8.2 System Information
In the navigation panel, click Basic Setting > System Info to display the screen as shown. Use this screen
to view general system information. You can check the firmware version number and monitor the Switch
temperature.
To Next Page
Loading...
