Chapter 48 Port
GS1350 Series User’s Guide
333
CHAPTER 48
Port
48.1 What You Can Do
• Use the Auto PD Recovery screen (Section 48.2 on page 333) to turn on automatic PD recovery on the
Switch and its Ethernet ports.
• Use the PoE Status screen (Section 48.3 on page 335) to view the current amount of power that PDs
are receiving from the Switch.
• Use the PoE Setup screen (Section 48.4 on page 338) to set the PoE power management mode,
priority levels, power-up mode and the maximum amount of power for the connected PDs.
• Use the Port Setup screen (Section 48.5 on page 340) to configure Switch port settings.
48.2 Auto PD Recovery
This screen lets you turn on automatic PD recovery on the Switch and its Ethernet ports. You can
configure whether the Switch uses LLDP or ping to check current status of a connected PD.
The ping is sent through the Switch's default management IP address to the designated port. To ping the
PD, the port must share the same VLAN as the Switch's management VLAN.
Figure 245 Auto PD Recovery Application
To open this screen, click Port > Auto PD Recovery.
To Next Page
Loading...
