ZyXEL Communications GS1350 Series - 8.7 Port Setup

Chapter 8 Basic Setting
GS1350 Series User’s Guide
99
Figure 75 Network Proxy Configuration Application
As of this writing, this setting only allows communication between the Switch and the NCC.
Figure 76 Basic Setting > IP Setup > IP Configuration > Network Proxy Configuration
The following table describes the labels in this screen.
8.7 Port Setup
Use this screen to configure Switch port settings. Click Basic Setting > Port Setup in the navigation panel
to display the configuration screen.
Table 31 Basic Setting > IP Setup > IP Configuration > Network Proxy Configuration
LABEL DESCRIPTION
Active Select this option to enable communication between the Switch and NCC through a proxy
server.
Server Enter the IP address (dotted decimal notation) or host name of the proxy server. When entering
the host name, up to 128 alphanumeric characters are allowed for the Server including special
characters inside the square quotes [~!@#$%^&*()_+{}|:”<>?-=[]\;’,./‘]
Port Enter the port number of the proxy server (1 – 65535).
Authentication Select this option to enable proxy server authentication using a Username and Password.
Username Enter a login user name from the proxy server administrator. Up to 32 alphanumeric characters
are allowed for the Username including special characters inside the square quotes
[~!@#$%^&*()_+{}|:”<>?-=[]\;’,./‘].
Password Enter a login password from the proxy server administrator. Up to 32 alphanumeric characters
are allowed for the Password including special characters inside the square quotes
[~!@#$%^&*()_+{}|:”<>?-=[]\;’,./‘].
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to reset the fields to your previous configuration.