ZyXEL Communications GS1350 Series - 31.4.7 Configure DHCPv4 VLAN Port

Chapter 31 DHCP
GS1350 Series User’s Guide
249
31.4.7 Configure DHCPv4 VLAN Port
Use this screen to apply a different DHCP option 82 profile to certain ports in a VLAN. To open this screen,
click IP Application > DHCP > DHCPv4 > VLAN > Port.
Figure 184 IP Application > DHCP > DHCPv4 > VLAN > Port
The following table describes the labels in this screen.
Delete Select the configuration entries you want to remove and click Delete to remove them.
Cancel Click Cancel to clear the check boxes.
Table 120 IP Application > DHCP > DHCPv4 > VLAN (continued)
LABEL DESCRIPTION
Table 121 IP Application > DHCP > DHCPv4 > VLAN > Port
LABEL DESCRIPTION
VID Enter the ID number of the VLAN you want to configure here.
Port Enter the number of ports to which you want to apply the specified DHCP option 82 profile.
You can enter multiple ports separated by (no space) comma (,) or hyphen (–). For example,
enter “3–5” for ports 3, 4, and 5. Enter “3,5,7” for ports 3, 5, and 7.
Option 82 Profile Select a pre-defined DHCP option 82 profile that the Switch applies to the specified ports in this
VLAN. The Switch adds the Circuit ID sub-option and/or Remote ID sub-option specified in the
profile to DHCP requests that it relays to a DHCP server.
The profile you select here has priority over the one you select in the DHCP > DHCPv4 > VLAN
screen.
Add Click this to create a new entry or to update an existing one.
This saves your changes to the Switch’s run-time memory. The Switch loses these changes if it is
turned off or loses power, so use the Save link on the top navigation panel to save your changes
to the non-volatile memory when you are done configuring.
Cancel Click this to reset the values above based on the last selected entry or, if not applicable, to
clear the fields above.
Clear Click Clear to reset the fields to the factory defaults.
Index This field displays a sequential number for each entry. Click an index number to change the
settings.
VID This field displays the VLAN to which the ports belongs.
Port This field displays the ports to which the Switch applies the settings.