ZyXEL Communications GS1350 Series - 38.4.1 Cluster Member Switch Management

Chapter 38 Cluster Management
GS1350 Series User’s Guide
302
38.4 Technical Reference
This section provides technical background information on the topics discussed in this chapter.
38.4.1 Cluster Member Switch Management
Go to the Clustering Management Status screen of the cluster manager switch and then select an Index
hyperlink from the list of members to go to that cluster member switch's Web Configurator home page.
This cluster member Web Configurator home page and the home page that you would see if you
accessed it directly are different.
Cancel Click Cancel to begin configuring this screen afresh.
Clustering
Candidate
The following fields relate to the switches that are potential cluster members.
List A list of suitable candidates found by auto-discovery is shown here. The switches must be
directly connected. Directly connected switches that are set to be cluster managers will not
be visible in the Clustering Candidate list. Switches that are not in the same management
VLAN group will not be visible in the Clustering Candidate list.
Password Each cluster member’s password is its Web Configurator password. Select a member in the
Clustering Candidate list and then enter its Web Configurator password. If that switch
administrator changes the Web Configurator password afterwards, then it cannot be
managed from the Cluster Manager. Its Status is displayed as Error in the Cluster
Management Status screen.
If multiple devices have the same password then hold [SHIFT] and click those switches to
select them. Then enter their common Web Configurator password.
Add Click Add to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Refresh Click Refresh to perform auto-discovery again to list potential cluster members.
The next summary table shows the information for the clustering members configured.
Index This is the index number of a cluster member switch.
MacAddr This is the cluster member switch’s hardware MAC address.
Name This is the cluster member switch’s System Name.
Model This is the cluster member switch’s model name.
Select an entry’s check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Remove Click the Remove button to remove the selected cluster member switches from the cluster.
Cancel Click Cancel to begin configuring this screen afresh.
Table 150 Management > Cluster Management > Configuration (continued)
LABEL DESCRIPTION