ZyXEL Communications GS1350 Series - 51.5 Configure SNMP Trap Group

Chapter 51 Security
GS1350 Series User’s Guide
370
51.5 Configure SNMP Trap Group
The Switch sends traps to an SNMP manager when an event occurs. From the SNMP screen, click Trap
Group to view the screen as shown. Use the Trap Group screen to specify the types of SNMP traps that
should be sent to each SNMP manager.
Figure 273 Security > Access Control > SNMP > Trap Group
The following table describes the labels in this screen.
Username Enter the username to be sent to the SNMP manager along with the SNMP v3 trap.
This username must match an existing account on the Switch (configured in the Management
> Access Control > SNMP > User screen).
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 188 Security > Access Control > SNMP > SNMP (continued)
LABEL DESCRIPTION
Table 189 Security > Access Control > SNMP > Trap Group
LABEL DESCRIPTION
Trap Destination IP Select one of your configured trap destination IP addresses. These are the IP addresses of the
SNMP managers. You must first configure a trap destination IP address in the SNMP Setting
screen.
Use the rest of the screen to select which traps the Switch sends to that SNMP manager.
Type Select the categories of SNMP traps that the Switch is to send to the SNMP manager.