ZyXEL Communications GS1350 Series - 52.4 Reboot System

Chapter 52 Maintenance
GS1350 Series User’s Guide
378
52.4 Reboot System
Reboot System allows you to restart the Switch without physically turning the power off. It also allows you
to load the Current Configuration, a Custom Default or the Factory Default configuration when you
reboot. Follow the steps below to reboot the Switch.
Click Maintenance > Maintenance > Reboot System to view the screen as shown next.
Figure 280 Maintenance > Maintenance > Reboot System
1 In the Reboot System screen, click a configuration button next to Reboot System with to reboot and load
that configuration file. The following screen displays.
If you select Current Configuration, make sure to save the Switch
settings as the current configuration in
the Maintenance > Maintenance > Save Configuration screen.
Figure 281 Reboot System: Use the Current Configuration Confirmation
If you select Factory Default, the following warning will appear.
Figure 282 Reboot System: Use the Factory Default Confirmation
If you select Custom Default, the following warning will appear.
Figure 283 Reboot System: Use the Custom Default Confirmation