ZyXEL Communications GS1350 Series - Global DHCP Relay Configuration Example

Chapter 31 DHCP
GS1350 Series User’s Guide
247
31.4.5 Global DHCP Relay Configuration Example
The follow figure shows a network example where the Switch is used to relay DHCP requests for the
VLAN1 and VLAN2 domains. There is only one DHCP server that services the DHCP clients in both
domains.
Figure 181 Global DHCP Relay Network Example
Configure the DHCP Relay screen as shown. Make sure you select a DHCP option 82 profile (default1 in
this example) to set the Switch to send additional information (such as the VLAN ID) together with the
DHCP requests to the DHCP server. This allows the DHCP server to assign the appropriate IP address
according to the VLAN ID.
Figure 182 DHCP Relay Configuration Example
Select an entry’s check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Delete Select the entries that you want to remove, then click the Delete button to remove the selected
entries from the table.
Cancel Click this to clear the check boxes above.
Table 119 IP Application > DHCP > DHCPv4 > Global > Port (continued)
LABEL DESCRIPTION
EXAMPLE