ZyXEL Communications GS1350 Series - 51.7 Configure SNMP User

Chapter 51 Security
GS1350 Series User’s Guide
372
51.7 Configure SNMP User
From the SNMP screen, click User Information to view the screen as shown. Use the User Information
screen to view SNMP users for authentication with managers using SNMP v3. An SNMP user is an SNMP
manager.
Figure 275 Security > Access Control > SNMP > User Information
The following table describes the labels in this screen.
Click Add or Edit button to open the following screen. Use this screen to create or edit SNMP users for
authentication with managers using SNMP v3 and associate them to SNMP groups.
* Settings in this row apply to all ports.
Use this row only if you want to make some of the settings the same for all ports. Use this row
first to set the common settings and then make adjustments on a port-by-port basis.
Changes in this row are copied to all the ports as soon as you make them.
Active Set this switch to ON to enable the trap type of SNMP traps on this port.
Set this switch to OFF to disable the sending of SNMP traps on this port.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 190 Security > Access Control > SNMP > Trap Group Port (continued)
LABEL DESCRIPTION
Table 191 Security > Access Control > SNMP > User Information
LABEL DESCRIPTION
Select an entry’s check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Index This is a read-only number identifying a login account on the Switch. Click on an index number
to view more details and edit an existing account.
Username This field displays the username of a login account on the Switch.
Security Level This field displays whether you want to implement authentication and/or encryption for SNMP
communication with this user.
Authentication This field displays the authentication algorithm used for SNMP communication with this user.
Privacy This field displays the encryption method used for SNMP communication with this user.
Group This field displays the SNMP group to which this user belongs.
Add Click this button to create new SNMP users for authentication with managers.
Edit Click this button to configure SNMP users for authentication with managers.
Delete Click this button to remove the selected entry from the summary table.