ZyXEL Communications GS1350 Series - 33.2.1 Erase Running-Configuration

Chapter 33 Maintenance
GS1350 Series User’s Guide
258
Figure 190 Management > Maintenance
The following table describes the labels in this screen.
33.2.1 Erase Running-Configuration
Follow the steps below to reset the Switch back to the Zyxel default configuration settings.
Table 124 Management > Maintenance
LABEL DESCRIPTION
Firmware
Upgrade
Click Click Here to go to the Firmware Upgrade screen.
Restore
Configuration
Click Click Here to go to the Restore Configuration screen.
Backup
Configuration
Click Click Here to go to the Backup Configuration screen.
Erase Running-
Configuration
Click Click Here to reset the configuration to the Zyxel default configuration settings.
Save
Configuration
Click Config 1 to save the current configuration settings to Configuration 1 on the Switch.
Click Config 2 to save the current configuration settings to Configuration 2 on the Switch.
Click Custom Default to save the current configuration settings to a customized default file on
the Switch. This file can be used instead of the Zyxel factory default configuration file.
Reboot System Click Config 1 to reboot the Switch and load Configuration 1 on the Switch.
Click Config 2 to reboot the Switch and load Configuration 2 on the Switch.
Click Factory Default to reboot the Switch and load the Zyxel factory default configuration
settings on the Switch.
Click Custom Default to reboot the Switch and load a saved customized default file on the
Switch.
Note: Make sure to click the Save button in any screen to save your settings to the
current configuration on the Switch.
Current This field displays which configuration (Configuration 1 or Configuration 2) is currently operating
on the Switch.
Tech-Support Click Click Here to see the Tech-Support screen. You can set CPU and memory thresholds for
log reports and download related log reports for issue analysis. Log reports include CPU history
and utilization, crash and memory.
Certificates Click Click Here to see the Certificate screen and import the Switch's CA-signed certificates.