Chapter 11 Static Multicast Forwarding
GS1350 Series User’s Guide
138
CHAPTER 11
Static Multicast Forwarding
11.1 Overview
This chapter discusses how to configure forwarding rules based on multicast MAC addresses of devices
on your network.
Use these screens to configure static multicast address forwarding.
11.1.1 What You Can Do
Use the Static Multicast Forwarding screen (Section 11.2 on page 139) to configure rules to forward
specific multicast frames, such as streaming or control frames, to specific port(s).
11.1.2 What You Need To Know
A multicast MAC address is the MAC address of a member of a multicast group. A static multicast
address is a multicast MAC address that has been manually entered in the multicast table. Static
multicast addresses do not age out. Static multicast forwarding allows you (the administrator) to forward
multicast frames to a member without the member having to join the group first.
If a multicast group has no members, then the switch will either flood the multicast frames to all ports or
drop them. Figure 109 on page 138 shows such unknown multicast frames flooded to all ports. With static
multicast forwarding, you can forward these multicasts to ports within a VLAN group. Figure 110 on page
139 shows frames being forwarded to devices connected to port 3. Figure 111 on page 139 shows
frames being forwarded to ports 2 and 3 within VLAN group 4.
Figure 109 No Static Multicast Forwarding
To Next Page
Loading...
