GS1350 Series User’s Guide
71
that port get sent to VLAN 2.
Figure 51 Initial Setup Network Example: Port VID
1 Click Advanced Applications > VLAN > VLAN Configuration in the navigation panel. Then click the VLAN
Port Setup link.
2 Enter 2 in the PVID field for port 1 and click Apply to save your changes back to the run-time memory.
Settings in the run-time memory are lost when the Switch’s power is turned off.
5.1.3 Configure Switch Management IP Address
If the Switch fails to obtain an IP address from a DHCP server, the Switch will use 192.168.1.1 as the
management IP address. You can configure another IP address in a different subnet for management
purposes. The following figure shows an example.
To Next Page
Loading...
