Chapter 45 Surveillance Mode
GS1350 Series User’s Guide
326
Action Click the Default button to reset the neighboring device to its factory default settings. A
warning message “Are you sure you want to reset the AP to factory default?” appears
prompting you to confirm the action.
• The Switch must support power sourcing (PSE) or the network device is a powered
device (PD).
• If multiple neighbor devices use the same port, the Default button is not available.
• You can only reset Zyxel powered devices that support the ZON utility.
Location This shows the geographic location of the neighbor device. This field will show “--” for
devices that do not support the ZON utility.
Desc. This shows the description of the neighbor device’s port which is connected to the Switch.
Firmware This shows the firmware version of the neighbor device. This field will show “--” for devices
that do not support the ZON utility.
MAC This shows the MAC address of the neighbor device.
Device Type This field displays the IP-based security products, for example IP camera or NVR (network
video recorder), that is connected to this Switch.
Flush Click the Flush button to remove information about neighbors learned on the selected
ports.
Table 163 Summary > Neighbor Detail (continued)
LABEL DESCRIPTION
To Next Page
Loading...
