GS1350 Series User’s Guide
363
The following table describes the labels in this screen.
Table 183 Networking > ONVIF
LABEL DESCRIPTION
ONVIF
Active Select Active to allow this Switch to send ONVIF packets to discover or scan for ONVIF-
compatible IP-based security devices connected to its ports. Make sure to enter the port
numbers in Port to allow discovery of ONVIF-compatible devices.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click this to reset the values in this screen to their last-saved values.
VLAN
Select an entry’s check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Index This is the index number of the ONVIF entry in the table.
VID This field displays the VLAN to which the ports belong.
Port This field displays the ports to which the Switch applies the settings.
Add Click this button to create new ONVIF settings for the VLAN port.
Edit Click this button to configure the ONVIF settings for the VLAN port.
Delete Click this button to remove the ONVIF settings for the VLAN port.
To Next Page
Loading...
