Chapter 3 Hardware Panels
GS1350 Series User’s Guide
40
CLOUD Green On The Switch has successfully connected to the NCC (Nebula Control Center).
Blinking The Switch cannot connect to the NCC because it is not registered.
Amber On The Switch is registered at NCC but cannot connect to the NCC. Please
check the Internet connection of the Switch.
Blinking The Switch is not registered at NCC and cannot connect to the NCC. Please
check the Internet connection of the Switch and register the Switch at NCC.
Off The Switch is operating in standalone mode. Nebula Control Center
Discovery is disabled in Basic > Cloud Management > Nebula Control Center
Discovery in the Switch’s Web Configurator.
LOCATOR Blue On The Switch is uploading firmware. While the Switch is doing this, do NOT turn
off the power.
Blinking Shows the actual location of the Switch between several devices in a rack.
The default timer is 30 minutes when you are configuring the Switch.
Off The locator is not functioning or malfunctioning.
PoE Usage MAX
Bar1 is the bar at
the bottom; bar
5 is the bar at
the top.
Green
(Bar1-Bar3)
On Each bar represents 20 percent of PoE Power consumption.
Bar 1: PoE power usage is below 20 percent of the power supplied budget.
Bar 2: PoE power usage is below 40 percent of the power supplied budget,
but over 20 percent of the power supplied budget.
Bar 3: PoE power usage is below 60 percent of the power supplied budget,
but over 40 percent of the power supplied budget.
Yellow
(Bar4)
On PoE power usage is below 80 percent of the power supplied budget, but
over 60 percent of the power supplied budget.
Red
(Bar5)
On PoE power usage is more than 80 percent of the power supplied budget.
Blinking Less than 5 percent of the power supplied budget remains. 5 percent is the
default value.
Off PoE power usage is 0 percent of the power supplied budget.
Ethernet Ports and PoE
LNK/ACT
1-5 (GS1350-
6HP)
1-8 (GS1350-
12HP)
1-16 (GS1350-
18HP)
1-24 (GS1350-
26HP)
Green Blinking The Switch is transmitting or receiving to or from a 1000 Mbps Ethernet
network.
On The link to a 1000 Mbps Ethernet network is up.
Amber Blinking The Switch is transmitting or receiving to or from a 10 Mbps or a 100 Mbps
Ethernet network.
On The link to a 10 Mbps or a 100 Mbps Ethernet network is up.
Off The link to an Ethernet network is down.
PoE
1-5 (GS1350-
6HP)
1-8 (GS1350-
12HP)
1-16 (GS1350-
18HP)
1-24 (GS1350-
26HP)
Green On Power supplied to all PoE Ethernet ports meets the IEEE 802.3at/bt standard.
Amber On Power supplied to all PoE Ethernet ports meets the IEEE 802.3af standard.
Off There is no power supplied.
Table 4 LED Descriptions (continued)
LED COLOR STATUS DESCRIPTION
To Next Page
Loading...
