ZyXEL Communications GS1350 Series - Page 45

Chapter 4 Web Configurator
GS1350 Series User’s Guide
45
6 Select the Web Configurator in Standard Mode that has a complete set of configuration for network
installation. Or select the Web Configurator in Surveillance Mode that has a set of menus specifically
designed for users who are mostly using the Switch for configuring and managing PoE devices like IP
cameras (Chapter 45 on page 322).
7 The Setup Wizard screen will appear after selecting the mode. You can use the Setup Wizard screen to
configure the Switch’s IP, login password, SNMP community, link aggregation, and so on. See Section 4.4
on page 51 for more information on the Setup Wizard screen. When you finish configuring the settings,
you can click the Apply & Save button to make the settings take effect, and save your configuration
into the Switch’s non-volatile memory at once. Check the screens to see if the settings are applied.
Note: Once you click the Apply & Save button, the settings configured in the Setup Wizard
screen will overwrite the existing settings.
Otherwise, click the Exit button. You can select the Ignore this wizard next time check box and click
Apply
& Save if you do not want the Setup Wizard screen to appear the next time you log in. If you want
to open the Setup Wizard screen later, click the Wizard icon in the upper right hand corner of the Web
Configurator.
Figure 29 Web Configurator: Wizard
8 If you did not change the default administrator password and/or SNMP community values, a warning
screen displays each time you log into the Web Configurator. Click Password / SNMP to open a screen
where you can change the administrator and SNMP passwords simultaneously. Otherwise, click Ignore
to close it.