Chapter 4 Web Configurator
GS1350 Series User’s Guide
63
Cloud
Management
This screen displays a link to a screen where you can enable or disable the Nebula Control
Center Discovery feature. If it is enabled, you can have the Switch search for the NCC (Nebula
Control Center). Another link takes you to the Nebula Switch Registration screen which has a
QR code containing the Switch’s serial number and MAC address for handy registration of the
Switch at NCC.
Advanced Application
VLAN This link takes you to screens where you can configure port-based or 802.1Q VLAN (depending
on what you configured in the Switch Setup menu). You can also configure a voice VLAN, a
MAC based VLAN or a vendor ID based VLAN in these screens.
Static MAC
Forwarding
This link takes you to a screen where you can configure static MAC addresses for a port. These
static MAC addresses do not age out.
Static Multicast
Forwarding
This link takes you to a screen where you can configure static multicast MAC addresses for
ports. These static multicast MAC addresses do not age out.
Filtering This link takes you to a screen to set up filtering rules.
Spanning Tree
Protocol
This link takes you to screens where you can configure the RSTP to prevent network loops.
Bandwidth
Control
This link takes you to a screen where you can configure bandwidth limits on the Switch.
Broadcast Storm
Control
This link takes you to a screen to set up broadcast filters.
Mirroring This link takes you to screens where you can copy traffic from one port or ports to another port
in order that you can examine the traffic from the first port without interference.
Link Aggregation This link takes you to screens where you can logically aggregate physical links to form one
logical, higher-bandwidth link.
Port Security This link takes you to a screen where you can activate MAC address learning and set the
maximum number of MAC addresses to learn on a port.
Time Range This link takes you to a screen where you can define different schedules.
Queuing Method This link takes you to a screen where you can configure queuing with associated queue
weights for each port.
Multicast This link takes you to screens where you can configure various multicast features and IGMP
snooping.
AAA This link takes you to a screen where you can configure authentication, authorization and
accounting services via external servers. The external servers should be RADIUS (Remote
Authentication Dial-In User Service).
DHCP Snooping This link takes you to screens where you can configure filtering of unauthorized DHCP packets in
your network.
Loop Guard This link takes you to a screen where you can configure protection against network loops that
occur on the edge of your network.
Errdisable This link takes you to screens where you can view errdisable status and configure errdisable
settings in CPU protection, errdisable detect, and errdisable recovery.
Green Ethernet This link takes you to a screen where you can configure green Ethernet settings in EEE, auto
power down, and short reach for each port.
LLDP This link takes you to screens where you can configure LLDP settings.
Auto PD
Recovery
This link takes you to a screen where you can enable and configure Auto PD Recovery on the
Switch.
ONVIF This link takes you to a screen where you can configure a specific VLAN to run ONVIF.
IP Application
DiffServ This link takes you to screens where you can enable DiffServ, configure marking rules and set
DSCP-to-IEEE802.1p mappings.
Table 17 Navigation Panel Links (Standard Mode) (continued)
LINK DESCRIPTION
To Next Page
Loading...
