Chapter 7 Status
GS1350 Series User’s Guide
83
Figure 65 Status
The following table describes the labels in this screen.
Table 21 Status
LABEL DESCRIPTION
Device Information
Device Type This field displays the model name of this Switch.
System Name This field displays the name used to identify the Switch on any network.
Boot Version This field displays the version number and date of the boot module that is currently on the
Switch.
System Location This field displays the geographic location of your Switch. You can change the setting in the
Basic Setting > General Setup screen.
Firmware
Version
This field displays the version number and date of the firmware the Switch is currently running.
System Time This field displays the current date and time in the UAG. The format is mm-dd-yyyy hh:mm:ss.
Hardware
Version
This field displays the hardware version number of the Switch. The integer is the model version,
and the decimal is the version of the hardware change. For example, V1.0 is a hardware version
for the Switch where 1 identifies the GS1350 Series, and .0 is the first hardware change.
System Up Time This field displays how long the Switch has been running since it last restarted or was turned on.
MAC Address This field displays the MAC addresses of the Switch.
Login
Timeout(mins)
This field displays how many minutes a management session can be left idle before the session
times out. After it times out you have to log in with your password again.
Serial Number This field displays the serial number of this Switch. The serial number is used for device tracking
and control.
To Next Page
Loading...
