ZyXEL Communications GS1900-8HP - The Loop Guard Port; The Port Edit Screen

Chapter 23 Configuration: Loop Guard
GS1900 Series User’s Guide
151
23.2.2 The Lo o p G ua rd Po rt
Use this screen to view the port’s Loop Guard settings. Click C o nfig ura tio n > Lo op G ua rd > Po rt to open
this screen.
Fig ure 152 Configuration > Loop Guard > Port
The following table describes the labels in this screen.
23.2.3 The Po rt Edit Sc re e n
Use this screen to configure Loop Guard settings on a port. Click Config ura tio n > Lo o p G uard > Po rt > Ed it
to open this screen.
Fig ure 153 Configuration > Loop Guard > Port > Edit
Table 99 Configuration > Loop Guard > Port
LABEL DESCRIPTIO N
Port
Port Displays the port index number.
State Displays whether the loop guard feature is Ena b le or Disa b le on the port.
Action Displays the action to take by the Switch. The options are Lo g , Shutd own Po rt, and Shutd own
and Lo g .
Edit Select this check box to configure the properties of a port. Click the Edit button change the
properties of the port.
Cancel Click C a nc e l to discard the changes.