Chapter 28 Configuration: LLDP
GS1900 Series User’s Guide
183
28.2.5 The Lo c a l Info rm a tio n Edit Sc re e n
Use this screen to configure the Po rt Ed it settings. Click C o nfig ura tio n > LLDP > Lo c a l Info rma tio n > Edit to
open this screen.
Capabilities
Supported
C a pa b ilitie s Suppo rte d describes the neighbor unit's capabilities. The possible capabilities are:
1. Other
2. Repeater
3. Bridge
4. WLAN Access Point
5. Router
6. Telephone
7. DOCSIS cable device
8. Station only
9. Reserved
When a capability is enabled, the capability is followed by (+). If the capability is disabled, the
capability is followed by (–).
Capabilities
Enable
Displays which capability is enabled.
Port ID Subtype Displays the Port ID Subtyp e .
MED Port Location
Port Displays the index number of the LLDP ports.
Coordinate Displays the location coordinate of the LLDP ports.
Civic Address Displays the location of the civic addresses in hexadecimal.
ECS ELIN Emergency Call Service (for example, E911 and others), such as defined by TIA or NENA.
Emergency Call Service ELIN identifier data format is defined to carry the ELIN identifier as used
during emergency call setup to a traditional CAMA or ISDN trunk-based PSAP. This format
consists of a numerical digit string, corresponding to the ELIN to be used for emergency calling.
Edit Select this check box to configure the properties of a port. Click the Edit button change the
properties of the port.
Cancel Click C a nc e l to discard the changes.
Table 129 Configuration > LLDP > Local Information (continued)
LABEL DESCRIPTIO N
To Next Page
Loading...
