Chapter 32 Configuration: Management
GS1900 Series User’s Guide
226
32.6 Te lne t/ SSH
32.6.1 The Te lne t Sc re e n
Use this screen to configure the Te lne t settings. Click C o nfig ura tion > Ma na g e m e nt > Te lne t/ SSH > Te lne t
to open this screen.
Fig ure 232 Configuration > Management > Telnet/SSH > Telnet
The following table describes the labels in this screen.
32.6.2 The SSH Sc re e n
Use this screen to configure the SSH settings. Click C o nfig ura tio n > Ma na g e m e nt > Te lne t/ SSH > SSH to
open this screen.
Fig ure 233 Configuration > Management > Telnet/SSH > SSH
Session Timeout Enter the session timeout value. The timeout can be between 0 and 86400 minutes.
Re-Generate
Certificate
Click this to renew the HTTPS certificate that is verified by a third party to create secure HTTPS
connections between your computer and the Switch. This allows you to securely access the
Switch using the Web Configurator.
Note: Re-generating the certificate will cause a network connection reset.
Apply Click A pp ly to save the changes.
Cancel Click C a nc e l to discard the changes.
Table 179 Configuration > Management > HTTP/HTTPS > HTTPS (continued)
LABEL DESCRIPTIO N
Table 180 Configuration > Management > Telnet/SSH > Telnet
LABEL DESCRIPTIO N
Telnet
State You can allow the Switch for remote Telnet access. The administrator uses Telnet from a
computer on a remote network to access the Switch.
• Ena ble : allow remote Telnet access.
• Disa b le : do not allow remote Telnet access.
Apply Click A pp ly to save the changes.
Cancel Click C a nc e l to discard the changes.
To Next Page
Loading...
