118/215
3.5 How to configure ACL to rate limit IP traffic
In some networks, it is necessary to configure rate limits among VLANs.
For example, VLAN 10 is for employees within the organization; VLAN 20
is for guests. By rate limiting VLAN 20, we can ensure better bandwidth
or network performance for users in VLAN 10. This example shows
administrators how to configure ACL to rate limit VLAN traffic. Results are
verified by observing and comparing the upload and download rate
between VLAN 10 and VLAN 20.
Configure ACL to rate limit VLAN traffic
Note:
All network IP addresses and subnet masks are used as examples in this article.
Please replace them with your actual network IP addresses and subnet masks. This
example was tested using XGS4600-32 (Firmware Version: V4.50) and GS2210-48HP
(Firmware Version: V4.30).
To Next Page
Loading...
