ZyXEL Communications GS2210 Series - Configure Switch-1 and Switch-2 for Stacking

92/215
www.zyxel.com
3.1.1 Configure Switch-1 and Switch-2 for Stacking
1 Set up Switch-1: Enter the web GUI and go to Menu > Basic
Setting > Stacking > Configuration. Key in the system priority
(The higher the number is, the higher priority it is to become a
master) and click “Apply”. Check “Active” and click “Apply”.
Switch-1 will reboot.
2 Set up Switch-2: Enter the web GUI and go to Menu > Basic
Setting > Stacking > Configuration. Key in the system priority
(The higher the number is, the higher priority it is to become a
master) and click “Apply”. Check “Active” and click “Apply”.
Switch-2 will reboot.
Note:
In this example, we set the priority of Switch-1 higher than Switch-2.
Therefore, Switch-1 will become the Master.