ZyXEL Communications GS2210 Series - How to Change the Switch Management IP Address to Avoid Accessing the Wrong Device; Configuration in the Switch-2

22/215
www.zyxel.com
1.3 How to change the switch management IP address to
avoid accessing the wrong device
This example shows administrators how to use the Web GUI to manage
the IP addresses of the switches and avoid administrators from
unintentionally accessing the wrong devices. As shown below, there are
two switches in the environment. Both default IP addresses of the two
switches are 192.168.1.1.
Two switches are using the same default IP address
1.3.1 Configuration in the Switch-2
1 Disconnect the link between Switch-1 and Switch-2.
2 Set the PC’s IP address on to the same subnet as the switches.
For example, set the PC IP address as 192.168.1.100.
Note:
All network IP addresses and subnet masks are used as examples in this article.
Please replace them with your actual network IP addresses and subnet masks. This
example was tested using XGS4600-32 (Firmware Version: V4.50).