160/215
5.5 How to configure the switch to send unauthorized users in
a guest VLAN
The example shows administrators how to use Guest VLAN for users that
fails or used an invalid user credential during 802.1x port authentication.
In a real application, we may need to allow guests to access the USG so
that they can access the Internet, but still isolated from Private-Server.
On the contrary, we have to allow the users with valid credentials to
only access the Private-Server.
Configure the switch to send unauthorized user in Guest VLAN
Note:
All network IP addresses and subnet masks are used as examples in this article.
Please replace them with your actual network IP addresses and subnet masks. This
example was tested using XGS4600-32 (Firmware Version: V4.50).
To Next Page
Loading...
